![]() Open Bluetooth settings on your Apple device, then select the controller from the list of nearby. This makes it discoverable by your Apple device. ![]() Press and hold the controller's Connect button for a few seconds to put the controller into pairing mode. ![]() No big deal, but happy to have understood how it works. Press the controller's Xbox button to turn the controller on. PDL(.) will normally return the value of nPdlPos if this is in the range 0-231. If the joystick is stable in a given position, there is no way for PDL(.) to ever return 232. This has to do with the fact that the first Read happens 10 cycles after the reset (and not 11), and the way PDL_CNTR_INTERVAL is computed (11.04 rather than 11).Īnd I guess the line nPdlPos = 280 only matters if one is not using PREAD but has written a different paddle position check routine. While playing with AppleWin I was trying to get familiar with the way PDL(.) works and found out this interesting behaviour. PDL(.) will normally return the value of nPdlPos if this is in the range 0-231 - This is because the 2-joystick version of Mario Bros expects the 2nd joystick to control Apple switch 2. Apple joystick 1's button now controls Apple switches 1 and 2. - When using 2 joysticks, button 1 is used by joystick 1 (Archon). If the joystick is stable in a given position, there is no way for PDL(.) to ever return 232. // If Apple joystick 1 is not NONE, then Apple joystick 0 only gets the use of Apple switch 0. While playing with AppleWin I was trying to get familiar with the way PDL(.) works and found out this interesting behaviour. This smells of a scriptable lua function to control the emulator behaviour. ![]() The 2nd one is interesting where it mentions that values on the edges are not reliable and should be clamped down, plus all the dead zones for most common gestures. They do an interesting remapping (pow) at the end to re-establish some round-ness in the middle where there would be no need to change anything. Fix Phasor card: use correct primary AY8913 for Phasor-native & MB modes (now checked in mb-audit v1.2). The first one has the same formula I posted above, just with too many ifs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |